Pipe clasps

Started by rosyfft, May 11, 2020, 04:32:18 PM

Previous topic - Next topic

rosyfft

I am looking for a detail part that clamps, clasps (?) a pipe to a building wall. Not sure what it is officially called. To go around a round pipe on the side of a building.
Any help? Either HO or O scale.

bparrish

Here is how I tie down spouts to a wall.

Drill a small hole in the structure..... maybe a #72 drill..........  then use a piece of .010" brass wire and make a loop around the pipe to be held and shove both ends through the wall.  Bend over and tack with super glue on the inside. Trim off short when glue is kicked off.


Otta get it.......... see photo below

see ya
Bob


Did you ever notice how many towns are named after their water towers ! ?