Not sure of the terminology, but I hope Mike doesn't mind if I use a detail from his morning picture to explain.
The rod used to support a canopy to the wall...where it connects to the wall...do y'alls use a piece of hardware of some kind like an NBW ... Just drill into the wall and insert the rod? I've tried a few ways, none of which have looked good to me. Suggestions? Thanks in advance.
I use Grandt line part #5156 nut/washer casting. Drill out the center hole and insert the wire thru this.
Jeff
Hi Dave & jeff:
You can also use Tichy turnbuckles. These were adjustable by using turnbuckle to lengthen or shorten them.
Karl
Thanks, all. :)