FOS REA Building, kit bash and scratch build.

[ACL1504]

I then held the new roof in place and drew a line on the inside of the roof and onto the roof panel.

I glued 8X8s inside the lines for roof supports.



Hey, it actually fits as intended!

[ACL1504]

I also needed to cut a new roof panel for the loading dock section.



Back in a few, Diet Pepsi time.

[ACL1504]

Here is how the gabled end of the main structure looked.



I'm always looking for ways to improve the look of my builds. On this one, I decided to add exterior rafters. I think you'll agree, it changes the entire look!

I stained and weathered 2X6s, measured and cut them to the correct length.



 

[ACL1504]

You also want to try to get a nice tight angle fit on the top.



Here is how it should look on the gable end. I added a 2X6 horizontally. You can see this board just above the windows.

[ACL1504]

Here is a close up view of the exterior rafter.



I also needed to cut a new roof panel for the enlarged side subassembly.

[ACL1504]

It is a little longer and wider. Old one shown on the bottom, new roof panel on top.



I extended the 2X6 horizontal board to the ends of the structure. I added them just below the freeze board.

[ACL1504]

I next glued the new roof decking in place and added 2X6s flush with the edge of the roof.




Done for today.

[GPdemayo]

All you need now is a roofing contractor.....