I've had several of the cast vent hoods, but cannot remember where, when or who makes / made the part. Any ideas? It is 7/16 inches in dia. I only need one to finish the model for Tom / ACL1504 , but probably should probably get more for future buildings
Frank / Erieman
Bar Mills?
Maybe an old JL Innovative Design detail part?
Steve and Bob,
The answer is no to both of your potential vendors. Keep looking. Thanks for the help.
Frank / Erieman
You might take a look at Model Tech Studios
John
Frank,
Best trains...Jill does a good job at getting parts out quickly. just ordered some for my Schramm build...
Loren...
I would try Details West. They have a ton of parts.
White metal, brass, resin or injection molded?
Hi Frank:
Let me see if I have one of those around. I Will check today OK.
Karl
Hi Frank:
Will this part work for you.
Karl
Quote from: postalkarl on September 29, 2017, 12:55:14 PM
Hi Frank:
Will this part work for you.
Karl
Karl,
Thank you for the offer. I have decided to eliminate the second turbine on the roof. With the roof water tank, it looks a little to congested. Thank you for looking.
Frank / Erieman
Hi Frank:
You are quite welcome. If you decide you need it just let me know OK.
Karl