who makes this part?

[Erieman]

I've had several of the cast vent hoods, but cannot remember where, when or who makes / made the part. Any ideas? It is 7/16 inches in dia. I only need one to finish the model for Tom / ACL1504 , but probably should probably get more for future buildings


Frank / Erieman

[sdrees]

Bar Mills?

[Oldguy]

Maybe an old JL Innovative Design detail part?

[Erieman]

Steve and Bob,


The answer is no to both of your potential vendors. Keep looking. Thanks for the help.


Frank / Erieman

[cuse]

You might take a look at Model Tech Studios


John

[fsmcollector67]

Frank,
Best trains...Jill does a good job at getting parts out quickly. just ordered some for my Schramm build...
Loren...

[PRR Modeler]

I would try Details West. They have a ton of parts.

[jbvb]

White metal, brass, resin or injection molded?

[postalkarl]

Hi Frank:

Let me see if I have one of those around. I Will check today OK.

Karl

[postalkarl]

Hi Frank:

Will this part work for you.

Karl

[Erieman]

Hi Frank:

Will this part work for you.

Karl

Karl,


Thank you for the offer. I have decided to eliminate the second turbine on the roof. With the roof water tank, it looks a little to congested. Thank you for looking.


Frank / Erieman

[postalkarl]

Hi Frank:

You are quite welcome. If you decide you need it just let me know OK.

Karl