Building a Kitwood Hill Models 45ft Gallows Turntable

[elwoodblues]

Oh Fun! Looking good~

Mine had an older N 20 type motor.

Thanks Philip,

From what I can gather I believe the supplied motor has changed over the years.

[elwoodblues]

Ron, you're flying on this build.
Great color on those ties.

Thanks Rick,

I'm having a ton of fun building this and with 3 day weekends, it gives me lots of time to model.  Glad you like the colour on the ties.

[elwoodblues]

Wow Ron. You are smoking through this build. Everything looks very professionally done.

Thanks Curt,

Building this has been a blast.

[elwoodblues]

Ron great work and attention to detail!! Looks like a winner to me.

Thanks Larry,

It's has been an easy build so far as the engineering is spot on with very little fitting or sanding required.

[elwoodblues]

God there must be a loco on the the other side waiting to get out of the terminal.
At the rate your going he won't have to wait long!!!

Excellent build Ron.

Jerry

Thanks Jerry,

The crew is working overtime to get this done as the yard crew almost lost one locomotive into the void forgetting that the original turntable went missing, the cause of which is still under investigation.

[friscomike]

Howdy Ron,

The turntable is progressing well.  Thank you for taking the time to document the process.  It is outstanding.

Have fun,
mike

[elwoodblues]

Howdy Ron,

The turntable is progressing well.  Thank you for taking the time to document the process.  It is outstanding.

Have fun,
mike

Thanks Mike,

Glad you are enjoying the process.

[elwoodblues]

Well my week at work is done and I have now time to get back to the turntable build.   So without further ado, lets get to it.

I think from this point forward I'll show each step as I complete them instead of saving two or three steps and then posting them.  The reason for this is that I can post while I let the stain dry for the next step.

Part 8 - Bridge Support Wheel Assemblies




First step is to stain the parts.  Shown here is the wheel support (at top) and the pieces required to build one wheel housing.





The sides and end of the wheel housing glued to the wheel support.





The wheel and axle installed in the wheel housing.





The axle capture plates installed.  These are a very snug fit so that the axle stays in place.





One completed wheel assembly.





The above steps were completed to complete the second wheel support assembly.

[elwoodblues]

The bridge support wheel assemblies attached to the bridge.

On to the next step. . . . . .