Critter (Bash)

[elwoodblues]

Nice looking lights Philip, hope the printing goes well.

[friscomike]

Howdy Philip,

Nice headlight design.  How did the prints turn out?

Have fun,
mike

[Rick]

Philip, glad the print went well.
Will you print a longer one?

[Philip]

Thanks Pausing. Heading to the grocery so I'll print it again later. The red was a way small. Center is on deck and if all else fails I'll try the left design.

[Philip]

Howdy Philip,

Nice headlight design.  How did the prints turn out?

Have fun,
mike

Thanks, Turned out ok except the bore for the headlight was undersized. Oops!

[Larry C]

Philip keep at it; I'm sure you'll get the results you want.

[friscomike]

Howdy Philip,

Nice headlight design.  How did the prints turn out?

Have fun,
mike

Thanks, Turned out ok except the bore for the headlight was undersized. Oops!

Philip, Funny, it seems I'm always adjusting the size or scale after the first print.  Someday maybe I'll figure it out.  Have fun, mike

[Philip]

Same here Mike.

[Philip]

Good enough. Now to wire the led in with a 570 ohm resistor and create a mounting point for the wires.

[friscomike]

Howdy Philip, The headlight turned out well. It certainly looks prototypical.  Nice work on the whole critter.  Have fun, mike

[PRR Modeler]

Looks great Philip.

[Rick]

Philip, nice work!

[ACL1504]

Philip,

The light looks great. Well done.

Tom 

[Philip]

Thanks Mike, Rick, Curt, and Tom.

[Larry C]

The light turned out really well and looks great installed on the critter.