Corrugated roof

Started by cduckworth, March 05, 2025, 08:30:37 AM

Previous topic - Next topic

cduckworth

We had a local model RR sale for a friend that has Parkinson's. I picked up the Walthers Vulcan Manufacturing kit and ordered the traveling crane to go with it. It arrived a couple weeks ago and as most Walthers kits it's a low parts count and goes together quickly. I sprayed the 'corrugated' roof with Tamiya gray printer and scribed horizontal lines. Then, using Tamiya masking tape, I masked off either side and used a sponge to simulate rust on the individual panels. After the rust dried I went back with a gray mix to further define the panels.�
Charlie Duckworth
Modeling the Mopac and Rock Island in the Missouri Ozarks.

deemery

Great job on the roof!  I think you got the right 'mix' of rust and metal.  

dave
Modeling the Northeast in the 1890s - because the little voices told me to

Rick

I agree with Dave that you got the right mix of rust and metal.

Jim Donovan

Thanks, I am going to use this photo as reference for a roof I need to weather.

Jim
Holland & Odessa Railroad

GPdemayo

Excellent metal roofing Charlie...... 8)
Gregory P. DeMayo
General Construction Superintendent Emeritus
St. Louis & Denver Railroad
Longwood, FL

Philip


ACL1504

"If we are to guard against ignorance and remain free, it is the responsibility of every American to be informed."
Thomas Jefferson

Tom Langford
telsr1@aol.com

Zephyrus52246

Love the roof.  When you stated you went back over with a grey mix, was it with the sponge technique or airbrushed?

Jeff

cduckworth

Quote from: Zephyrus52246 on March 05, 2025, 02:02:40 PMLove the roof.  When you stated you went back over with a grey mix, was it with the sponge technique or airbrushed?

Jeff
Jeff
I just brush painted the gray.
Charlie Duckworth
Modeling the Mopac and Rock Island in the Missouri Ozarks.

Deem

Quote from: cduckworth on March 05, 2025, 08:30:37 AMWe had a local model RR sale for a friend that has Parkinson's. I picked up the Walthers Vulcan Manufacturing kit and ordered the traveling crane to go with it. It arrived a couple weeks ago and as most Walthers kits it's a low parts count and goes together quickly. I sprayed the 'corrugated' roof with Tamiya gray printer and scribed horizontal lines. Then, using Tamiya masking tape, I masked off either side and used a sponge to simulate rust on the individual panels. After the rust dried I went back with a gray mix to further define the panels.�
Impressive, Charlie. All you need now is some scale fresh bird droppings on it.

Michael Hohn

Very realistic results.

Mike

labdad

I get to see lots of metal roofs driving around here.
Yours is spot on!
MJinTN

KentuckySouthern

 ;) Incredible looking roof!  Well done. 
Karl

ReadingBob

Great job! I like to take pictures of rusted roofs to use as inspiration.

Bob Butts
robertbutts1@att.net

There's a fine line between Hobby and Mental Illness.

Powered by EzPortal