Bar Mills Rustys Radiator 2016 Challenge Build

[Janbouli]

Great job so far Jim

[Powersteamguy1790]

Nice work Jim. 

Stay cool and run steam......

[MASIGMON]

Jim,
Nice build! I like your colors.  Clean weathering

Karl,
Thanks for your photo's of your Rusty build.  I had forgot when you built the kit. I have sent to you a PM

Mike Sigmon

[jimmillho]

Thanks for all your comments guys.

I do not have a place for this on my layout, so OI just will put it somewhere and then finish the weathering and placement of the castings and other things.

Jim

[postalkarl]

Hi Jim:

As I said you colors look great. Can't wait to see it finished. Are you going to make it into A small diorama?

Karl

[jimmillho]

Hi Jim:

As I said you colors look great. Can't wait to see it finished. Are you going to make it into A small diorama?

Karl

Thanks for your comment Karl.  I appreciate them.

I do not have a place for this on my layout, so it will most likely just go up on the shelf with some other things that don't have a place to go.

Jim

[jimmillho]

Everything is finished but I do not have a place for this anywhere on my layout at this time.  So here are some final pictures with the castings and a little weathering.

[Janbouli]

[MASIGMON]

I hope I am not overstepping my use of reply to this post. 
I found back in June 2004 Robert Bennett scratch built an old shed that Bar Mills used as a starting point for the Kit Rustys Radiator.
If you have a copy of the RMC June 2004 it is good reading for those who might build this kit in the future & want to make a few changes

Mike Sigmon
Jacksonville, FL 

[jimmillho]

Thanks Jan,
I love your graphics

Jim

[jimmillho]

I hope I am not overstepping my use of reply to this post. 
I found back in June 2004 Robert Bennett scratch built an old shed that Bar Mills used as a starting point for the Kit Rustys Radiator.
If you have a copy of the RMC June 2004 it is good reading for those who might build this kit in the future & want to make a few changes

Mike Sigmon
Jacksonville, FL

Mile,
Thanks for that little piece of information.  Somebody may need that someday in their build.

Jim

[Powersteamguy1790]

Looking good Jim.

Stay cool and run steam......

[R Edington]

    Looks great, Jim

[ak-milw]

Nice job on Rusty's Jim

[jimmillho]

Bob, Rodney, Andy,.....Thanks for following this build and for your comments,  I appreciate it very much.

Jim