Blacksmith Shop

Started by Philip, May 30, 2026, 08:09:55 AM

Previous topic - Next topic
Print
Go Down Pages 1 ... 8 9 10
User actions

Philip

#135
June 28, 2026, 08:09:49 AM
Quote from: Larry C on June 28, 2026, 08:06:39 AMPhilip the cupola will be a nice detail addition. I'm with you on the roofing especially if it can't be seen.
Had to laugh at Karl's "new clamp".

The remedy for the lost 10mm.  8)   

Jerry

#136
June 28, 2026, 10:19:34 AM
With all that rain you should be able to finish this up this week???  ;D
Everything is looking good.

Jerry
"And in the end, it's not the years in your life that count. It's the life in your years." A. Lincoln

Philip

#137
June 28, 2026, 10:49:18 AM
Quote from: Jerry on June 28, 2026, 10:19:34 AMWith all that rain you should be able to finish this up this week???  ;D
Everything is looking good.

Jerry

Maybe not....but thanks for the motivation! lol

Philip

#138
June 29, 2026, 08:58:07 PM Last Edit: June 29, 2026, 09:22:50 PM by Philip
Fishing buddy helped me today. The big one!
Also messing around with dormer position. They are just tacked on with a dot of glue. Not sure if the current position is good? Any suggestions? I was thinking having 3 on each side of the roof?

Adding wood veneer over the 3d prints is pretty easy. CA to the plastic and then wood glue to joint the wood trim. The roofing will be tin.

20260629_203043.jpg
20260629_202943.jpg
20260629_202916.jpg
20260629_202828.jpg

Tomorrow I'll prime the two dormers and figure out the wood layout. I primed the coupla in camo brown. Good enough.

Thanks for looking and I'm open to suggestions, good, bad and unlikeful 8). 

We topped out a 107 today with the heat index. OMG!

Philip




Print
Go Up Pages 1 ... 8 9 10
User actions
Powered by EzPortal