Scratchbuilding Scranton - North Washington Avenue Project

Started by EricQuebec, March 21, 2021, 05:00:01 PM

Previous topic - Next topic

deemery

Everything about this is first-rate!  The prototype, the modeling, the paint/finish...   


dave
Modeling the Northeast in the 1890s - because the little voices told me to

Mark Dalrymple

Looking fantastic, Eric!

I'm looking forward to your next update.

Cheers, Mark.

jbvb

I've just read from the beginning. - nice work, Eric.
James

EricQuebec

Quote from: deemery on May 23, 2021, 05:23:19 PM
Everything about this is first-rate!  The prototype, the modeling, the paint/finish...   


dave
Thank you Dave  for your good comments .
Eric

EricQuebec

Quote from: Mark Dalrymple on May 23, 2021, 06:02:08 PM
Looking fantastic, Eric!

I'm looking forward to your next update.

Cheers, Mark.
Thank you very much Mark. Be patient for the next update. it will take  few weeks.
Eric

EricQuebec

Quote from: jbvb on May 23, 2021, 09:26:53 PM
I've just read from the beginning. - nice work, Eric.
Thank you for watching  Matt,
Eric

GPdemayo

Great work on those details for the front elevations Eric..... 8)
Gregory P. DeMayo
General Construction Superintendent Emeritus
St. Louis & Denver Railroad
Longwood, FL

S&S RR


Eric

Wow - Beautiful work. I'm really enjoying your build thread.
John Siekirk
Superior & Seattle Railroad

Oldguy

Bob Dye
Livin large on a pond

EricQuebec

Quote from: GPdemayo on May 24, 2021, 07:41:55 AM
Great work on those details for the front elevations Eric..... 8)

Thank you very much Greg
Eric

EricQuebec

Quote from: S&S RR on May 24, 2021, 09:06:07 AM

Eric

Wow - Beautiful work. I'm really enjoying your build thread.
thank for your good  comment John.
Eric

EricQuebec


Rail and Tie

Just wonderful. Bloody Wonderful!


Not sure I would want to try that as a laser cut kit, never mind scratch building it!
Darryl Jacobs
Inter-Action Hobbies
www.interactionhobbies.com

EricQuebec

Quote from: Rail and Tie on May 24, 2021, 07:17:18 PM
Just wonderful. Bloody Wonderful!


Not sure I would want to try that as a laser cut kit, never mind scratch building it!

However, it be a wonderful laser cut kit, difficult to build but very rewarding :) :) :)
Thank you Darryl for your comment.
Eric

EricQuebec

Hello Everyone,
After few weeks to work an a small project for our friend Ton (ACL1510), I'm slowly back to this project (understand that summer is short in Québec, and I spent a lot of time to play outdoor rather than in my mancave).
For the first time in many years of building kit and scratchbuild building, I've make an interior for the second building, It will be a kind of grocerie, with two small personna : Ms. Simpson (Sally), and Mr. Panzanelli, an Italian Grocer

Once this small scene was done, I've glue it inside the building

Then, I've glue the front of the building just aside of the first building, and make the rear wall. For this that is like a slice of ham between 2 pieces of bread no side where needed


Then I've done the roof, and the back of the cornice with brick material. AN other time the roof is cover with tar paper. More details will be added later.

To be continued in a few




Powered by EzPortal